DRAW & DOSE CALCULATOR
Use our Peptide Calculator below to calculate accurate dosages for administering peptides using a syringe. Simply select your parameters, and our calculator will give you the results.
Dose of Peptide
The amount you want to inject each time.
Tip: peptide protocols often start in the 0.1 – 0.5 mg range and titrate up.
Peptide Strength
corresponds with the size of your vial
- BPC-15710 mg
- TB-50010 mg
- NAD+1000 mg
Bacteriostatic Water
determines peptide concentration
- GLP-1s2 – 3 mL
- Peptides3 mL
- NAD+5 mL
Result
Peptide Dose
Draw Syringe To
Fill to this mark on a U-100 syringe.
Your Vial Contains
Concentration
For research and educational purposes only. Not a substitute for medical advice. Always verify reconstitution and dosing with a qualified healthcare professional before use.
Peptide Dosage Setup Guide
Set Your Dose
Enter 250mcg which is the same as 0.25mg as your desired research dose. You want each dose to contain 250mcg of peptide, so you specify this amount.
FAQ
Example: CalculatingYour Peptide Dose
In this example we will assume your peptide strength is 5mg, and you will add 3mL of bacteriostatic water. Your goal is to inject 250 mcg of peptide into your subject.
Enter 250mcg which is the same as 0.25mg as your desired research dose. You want each dose to contain 250mcg of peptide, so you specify this amount.
Summary
By following these steps and using the peptide calculator, you determine that mixing 5mg of peptide with 3mL of bacteriostatic water creates a solution with a concentration of 1.7 mg/mL. To get a dose of 250mcg, you need to draw up 0.15mL (or 15 units) of this solution.